|
Price: $200.00 each CNC
- Easy setup! All you need to do is input the phone number to call, and the data to send.
- Software only, no hardware, no wiring into the CNC. All that is needed is a phone line run to the control.
- One phone line can service many CNCs
- Repeat paging in case the first page is not received
- Repeat ‘try to send’, if another CNC is using the phone line
- Uses modem commands so you can even call your cell phone if desired. You can send a pause, three tones and a pause again to represent CNC #3. A comma is a pause “,111,111,111”
- Easy access from the Citizen Control by using the “Win” key to toggle to and from WinPager.
- Easy pager off/on, both in one button. Less keys to press on the Windows control.
|
|
Which type of CNC does WinPager support?
WinPager was developed for the Mitsubishi Meldas M635 control. This control is used on Citizen Cincom models L5-16/20, M2-12/16/20/32, C16, FL-25/32/42.
How it works:
WinPager runs in the background while the CNC is running. You can’t even see it unless you call it up. Every 5 seconds WinPager will check the Mitsubishi system for any alarms. If an error is reported then WinPager will make the call. WinPager will then wait and then send as many pages as you set for confirmation.
|
